Black leather GT3 seat. Glossy black seat back finish. Seats come with the seat mounting brackets and slider units already assembled. They are ready to install once the stock seats are removed and use the same 4 mounting bolts that hold in the stock seats.

Embossed Porsche crest on head rest. ***Note: Before starting the installation process, use towels or blankets to cover the door sills and center console area so that the seat rails don't have a chance to scratch/damage the interior when removing the stock seats and installing the new seats***

Brey-Krause driver's side seat mount lowering brackets. Lowers seat by one inch over the standard mounting brackets that comes with the seat.

Plastic seat rail covers removed from the front portion of the slider rails. They must be removed from the rails in order to access the front mounting bolts. Pull the tabs in the center portion of the covers up and slide the covers off by pulling them forward towards the foot well.

***Note1: If you have electric seats...Raise the seat bottom to it's highest position. This makes it easier to access and remove the seat belt recepticle plug wire from the main electrical harness under the seat prior to pulling the seat out of the car.

***Note2:YOU MUST REMOVE IGNITION KEY FOR THE ENTIRE INSTALLATION PROCESS, OTHERWISE A WARNING LIGHT WILL COME ON AND WILL NEED TO BE RESET AT THE DEALER***

View of the front slider mounting bolt after the cover has been removed. The bolt is an external torx E12 type. I used the E12 torx socket with a 3/8" rachet drive.

It helps to use a driver extender piece, especially for the inside bolt near the center console since the seat slider lever may be obstructing the bolt somewhat.

Seat mounting bolts removed, four per seat.

View of the rear mounting bolt. There is no cover to remove and it is readily accessible by sliding the seat all of the way forward.

Here is the view of the wiring harness after it has been unplugged. To unplug the unit after the seat bolts have been removed, cut the plastic tie straps and pull out the sides of the larger female plug recepticle that remains with the stock seat since it is wired into it. The harness is accessible by tilting the seat on it's side with the underside of the seat facing the rear center console. You can access the driver's side wire harness from the passenger side and vice versa once the seats are on their sides.