Components: 950W Audison LXR6.9 (5 channel config), Nakamichi CD400, Morel 5" Elates(f), Hertz 4" Co-Axial(r), Morel 6"(subs).
Viewed: 192 times.
|
RCA style cables carry signal from NAK to Amp and additional set of wires for front dash mid range speaker pass through previously un-used rubber grommet behing battery.
Viewed: 164 times.
|
Wires will have to be run around front of battery and through grommet to trunk area.
Viewed: 156 times.
|
Grommet is drilled top and bottom in order to keep power lead 2" from speaker cables.
Viewed: 139 times.
|
Ground lead is attached to previous OEM amp mounting point
Viewed: 126 times.
|
OEM head unit is removed with Porsche keys.
Viewed: 146 times.
|
OEM harnesses.
Viewed: 130 times.
|
RCA cables will be fed to rear of DIN area for head unit. Speaker cables will be routed to front dash mid-range speakers. All other speakers use OEM wiring, but due to 3-way componets up front, one more set of wires must be added.
Viewed: 127 times.
|
Radio harness adapter is connected to OEM harness (only Power, remote amp on, power antennae booster and ground required - all sound signals will travel through RCA cables). RCA cables are in position for connection to NAK. Antennae adapter is installed to mate OEM to NAK.
Viewed: 137 times.
|
DIN style bracket for NAK is inserted, then metal tabs on side are bent to secure in place.
Viewed: 132 times.
|
Connections are made and the NAK is pushed into place.
Viewed: 176 times.
|
Wiring for Audison amp is positioned for amp installation.
Viewed: 144 times.
|
Wire is routed around front of battery to grommet on passenger side.
Viewed: 135 times.
|
Battery installed with wires secured at top/front of battery.
Viewed: 132 times.
|
Audison amp, Nakamichi CD400 and Morel cross-overs are installed. End of first day (10 hours - a lot of reading and planning involved).
Viewed: 147 times.
|
All factory speaker runs were utilized, but multi-pin connected for quick disconnect
Viewed: 138 times.
|
One of two multi-pin connectors installed
Viewed: 134 times.
|
Rear co-axial fitted
Viewed: 170 times.
|
Factory subwoofer enclosure and Morel 6" subs during fab process
Viewed: 180 times.
|
Sub enclosure ready for speakers
Viewed: 154 times.
|
Subs installed
Viewed: 170 times.
|
Sub enclosure ready for re-installation
Viewed: 150 times.
|
Speaker wires that run to multi-pin connectors
Viewed: 136 times.
|
Cables marked and pins soldered in place
Viewed: 124 times.
|
Amp install complete
Viewed: 132 times.
|
Amp install completeIMG 2883
Viewed: 154 times.
|
Test Fit of false floor carpeted to match. Loss of 4" of trunk depth.
Viewed: 135 times.
|
Door panel off for speaker install
Viewed: 157 times.
|
Door speaker installed after a bit of dremel tool work...
Viewed: 192 times.
|
Door speaker install complete
Viewed: 148 times.
|
IMG 7128
Viewed: 47 times.
|
IMG 7130
Viewed: 48 times.
|
IMG 7136
Viewed: 54 times.
|
